Scotts Rockwool Cloning Guide
Rockwool Cloning Guide
By Scott K. Progressive Growth1. In a 5 gallon bucket, fill with 3 gallons of water
2. Add 13 drops of Superthrive per gallon (39 drops total)
3. Adjust PH level of water to 5.0
4. Add rockwool cubes to water and soak for 24 hours
5. Next day pull cubes out of water and extract 80% of the water from the cube
6. Put some of your cloning gel/powder into a clean small cup
7. Take some of the water you soaked the cubes in and put into a clean bowl
8. Cut clones and place cut end in the bowl of water for 20 minutes
9. Dip cuttings in gel/powder and insert cutting into cube
10. If hole provided in cube is not the right size, then make a new hole
11. Place cube with clone in it into prop flat (30-35 per flat), place humidity dome on flat and put under 24 hours of light
12. Clean domes of moisture at least twice per day
13. In 4-5 days or when very dry, add small amount of water to each cube
(dip cube in bowl of water about ½ way up)
If Superthrive is not available,
Use another B1 product. (B52 / Vitamax / Thrive Alive)
 |
